Here's what i bought:
* Adapter Plate for vehicle
* Shaft Coupler - Motor to transmission(clutch-less)
* 0-5k (pb5)Throttle Box
* 40 ft of #2/0 ga. Wire Cable
* Contactor- Kilovac EV200 (2000 amp rupture 200 amp continuous)
* 50-150 VDC Volt Meter
* 0-500 Amp Meter
* 50mv - 500 Amp Shunt
* Gauge Holder Bracket
* 12 - High Current Ring Terminals
* 40 - Battery Cable Terminals
* Fuse - 400 amp slow blow
* Quickcharger 120 VDC (Smart Charger)
* 12 vdc Smart Battery Charger (for accessory battery)
It should all arrive in about a week
All i have left to buy is the motor and the batteries
I plan to set up all this stuff with the controller, then mount and connect the motor. At this point i can test everything and get the wheels moving slowly off one battery. After all of that is working ill purchase and install the batteries and bed DONE!!
Saturday, July 10, 2010
Subscribe to:
Post Comments (Atom)
1 comments:
Jake,
Great job on the controller. That did not take you long. If you need a Sam's Card we can send Grandpa's for you to use. If you pay cash they will not pay attention if you are Allan Henry.
Love Grandma and Grandpa
Post a Comment